03/08/2014
Wanna know how to do water marble nail art..??
You can do it in these 17 easy steps..!!
Step 1:Apply a base coat to your nails. This will help protect your natural nails from turning yellow and breaking.
Step 2:Once the base coat has completely dried, put some Vaseline, lip balm, or scotch tape around your nail. This will make the clean up process so much easier in the end.
Step 3:Take out as many colors that you want in the design. Use new and expensive brands. We do not want the polish to be too watery or too thick!
Step 4:Choose an old, unwanted bowl. The marbling process will ruin the bowl. Select carefully.
Step 5:Fill a bowl with filtered water. Make sure it's room temperature, or keep the water out for an hour or two.
Step 5:Fill a bowl with filtered water. Make sure it's room temperature, or keep the water out for an hour or two.
Step 6:Choose a polish and take out the wand. Don't try to remove the polish drop on the tip of the brush. Hold it over the bowl, and the drop will fall in, and quick move across the water's surface.
Step 7:Do the same with another polish of your desire, and drop the polish in the center of the other polish.
Step 8:Keep alternating until desired levels are achieved.
Step 9:Taking a toothpick, divide the design in two.
Step 10: Make as many lines in the design as wanted.
Step 11 :When done, dip your nail into bowl wait ten seconds for the outer nail polish to dry, and take out.Then with the toothpick in a spinning motion clean the nail polish in the bowl.
Step 12 :The design should be printed onto the nail.
Step 13: Don't worry it will be messy at first, but you can clean it up using cotton buds and nail polish remover.
Step 14:Repeat steps for all the other nails in the same way.
Step 15:Again clean up around them with a nail-polish remover.
Step 16:When dry, apply a top coat.
Step 17 :Finished
Oops i forgot to tell that there is an 18th step too....
Step 18 : Dont forget to hit like ....!!